LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Rendezvous CXL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls & Fuel - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: Tap out sensor mounting hole in engine head to remove any thread sealant residue. Clean any sealant residue from the old sensor and apply RTV sealant to threads if the old sensor is to be reused.
    Fig 1: Identifying ECT Sensor
    GM1087791Courtesy of GENERAL MOTORS CORP.
  1. Apply thread sealant GM P/N 12345382 (Canadian P/N 10953489) or equivalent, to the sensor threads.
  2. NOTE: Refer to Fastener Notice .
  3. Install the ECT sensor.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

  4. Fig 2: ECT Sensor Harness Connector
    GM1641073Courtesy of GENERAL MOTORS CORP.
  5. Connect the fuel injector harness electrical connector to the ECT sensor.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  8. Fill the cooling system. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (Vac-N-Fill) .