LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Rendezvous CXL >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

NOTE: Before installing the starter motor to the engine, tighten the nut next to the cap on the solenoid BAT terminal. If this terminal is not tight in the solenoid cap, the cap may be damaged during installation of electrical connections and cause the starter motor to fail later.
    Fig 1: Starter
    GM1644900Courtesy of GENERAL MOTORS CORP.
  1. Position the starter to the engine block.
  2. NOTE: Refer to Fastener Notice .
  3. Install the starter bolts.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

  4. Fig 2: Engine Harness Terminal
    GM1642633Courtesy of GENERAL MOTORS CORP.
  5. Install the engine harness terminal (2) to the starter solenoid.
  6. Install the starter solenoid "S" terminal nut (3).

    Tighten:  Tighten the nut to 3 N.m (27 lb in).

  7. Install the positive battery cable terminal (4) to the starter solenoid.
  8. Install the starter solenoid "BAT" terminal nut (5).

    Tighten:  Tighten the nut to 13 N.m (115 lb in).

  9. Fig 3: Front Transaxle Closeout Cover
    GM1642631Courtesy of GENERAL MOTORS CORP.
  10. Install the front transaxle closeout cover.
  11. Install the front transaxle closeout cover bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  12. Lower the vehicle.
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .