LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Rendezvous CXL >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Positive Battery Cable Terminal At The Junction Block
    GM1644820Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Loosen the positive battery cable bolt at the battery.
  3. Remove the positive battery cable from the battery.
  4. Remove the junction block cover.
  5. Remove the positive battery cable to junction block nut (1).
  6. Remove the positive battery cable terminal from the junction block.
  7. Fig 2: Positive Battery Cable Terminal At The Generator
    GM1644823Courtesy of GENERAL MOTORS CORP.
  8. Reposition the positive battery cable terminal boot at the generator.
  9. Remove the positive battery cable terminal nut.
  10. Remove the positive battery cable terminal from the generator.
  11. Fig 3: Battery Cable Clips On The Side Rail And Lower Radiator Support
    GM1644822Courtesy of GENERAL MOTORS CORP.
  12. Remove the negative battery cable ground bolt from the radiator support.
  13. Separate the negative battery cable ground from the fog lamp harness ground.
  14. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  15. Remove the lower radiator baffle. Refer to Radiator Air Baffle Assemblies and Deflectors .
  16. Remove the battery cable from the clips (1) on the side rail and lower radiator support.
  17. Fig 4: Positive Battery Cable Terminal At The Starter
    GM1644824Courtesy of GENERAL MOTORS CORP.
  18. Remove the starter solenoid nut.
  19. Remove the positive battery cable terminal from the starter.
  20. Fig 5: Negative Battery Cable At The Transaxle Stud
    GM1642639Courtesy of GENERAL MOTORS CORP.
  21. Remove the negative battery cable nut (3) from the transaxle stud.
  22. Remove the negative battery cable terminal (4) from the stud.
  23. Lower the vehicle.
  24. Remove the battery cable assembly from the vehicle.
  25. Place the cable assembly on a work bench.
  26. Cut the tape around the cable conduit.
  27. Open the conduit and remove the positive battery cable.