LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

  1. Install the power steering pressure hose to the vehicle.
  2. Fig 1: Removing/Installing Power Steering Hose Fitting
    GM254768Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the power steering pressure hose to the power steering pump.

    Tighten:  Tighten the power steering pressure hose to the power steering pump to 30 N.m (22 lb ft).

  4. Fig 2: View Of Steering Rack & Related Components
    GM460600Courtesy of GENERAL MOTORS CORP.
  5. Install the power steering pressure hose to the power steering gear.

    Tighten:  Tighten the power steering pressure hose to the power steering gear to 30 N.m (22 lb ft).

  6. Install the power steering hose retainer (2) to the engine frame.
  7. Install the power steering pressure hose into the power steering hose retainer.
  8. Install the power steering gear heatshield. Refer to Power Steering Gear Heat Shield Replacement .
  9. Lower the vehicle.
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .