LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) - 3.8L (L36 And L67) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Fuel Filler Tube and Fuel Filler Hose
    GM891297Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank if previously removed. Refer to Fuel Tank Replacement .
  2. Install the fuel filler tube (1) into the fuel filler hose (2).
  3. Fig 2: View of Wheel House Filler Pipe Opening Cover, Bolt, Ground Strap, Fuel Fill Hose, Fuel Fill Pipe, Sealing Ring, and Fuel Filler Cap
    GM891295Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Position the fuel filler tube (3) for best fit and alignment then secure the fuel filler tube hose clamp (4).

    Tighten:  Tighten the clamp to 3.5 N.m (31 lb in).

  5. Install the bolt (7) to the fuel filler tube ground wire (6).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  6. Install the wheel house opening fuel filler tube cover (5).
  7. Lower the vehicle.
  8. Install the sealing ring (2) around the fuel filler tube (3).
  9. Add fuel to the fuel tank.
  10. Inspect for fuel leaks.
  11. Install the fuel filler cap (1) and close the fuel filler door.