LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2004 >> LeSabre Custom, 4T65E/M15 >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Crossover Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Exhaust Crossover
    GM42230Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Exhaust System Inspection Notice in Cautions and Notices.
  1. Place the NEW exhaust crossover seal over the exhaust crossover.
  2. Insert the exhaust crossover into the right exhaust manifold.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts securing the exhaust crossover to the exhaust manifolds.

    Tighten:  Tighten the exhaust crossover bolts to 20 N.m (15 lb ft).

  5. Fig 2: View Of Exhaust Crossover Heat Shield
    GM153575Courtesy of GENERAL MOTORS CORP.
  6. Install the power brake booster heat shield to the exhaust crossover.
  7. Install the two nuts securing the power brake booster heat shield to the exhaust crossover.

    Tighten:  Tighten the power brake booster heat shield nuts to 20 N.m (15 lb ft).

  8. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.8 L.
  9. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) in Engine Mechanical - 3.8 L.