Removal Procedure
- Lower the door window to the full down position.
- Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Peel back the rearward half of the water deflector. Refer to Water Deflector Replacement - Front Door .
- Remove the window inner belt seal. Refer to Sealing Strip Replacement - Front Door Window Belt Inner .
Courtesy of GENERAL MOTORS CORP.
- Pull the lower rear portion of the window weatherstrip out of the door frame far enough in order to gain access to the lower fastener of the door frame applique.
Courtesy of GENERAL MOTORS CORP.
- Remove the upper run channel fastener (1), which is also the lower door applique fastener.
- Reinstall the window weatherstrip into the door frame.
- Connect the door trim panel wire harness.
- Run the window up until there is a 25.4 mm (1 in) opening at the top.
- Remove the lower run channel fastener (2).
- Pull the run channel down in order to clear the window.
- Remove the run channel.