Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 4: Lack of communication may be because of a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
- 5: The symptom list in Symptoms will determine the correct diagnostic procedure to use.
- 6: The presence of DTCs which begin with a "U" indicate some other module is not communicating. The specified procedure will collect all the available information before you perform tests.
Diagnostic System Check - Engine Electrical
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Perform the Battery Inspection/Test. Refer to Battery Inspection/Test . Does the battery pass the test? |
Go to Step 2 | - |
| 2 |
|
Go to Step 3 | Go to Scan Tool Does Not Power Up in Data Link Communications |
| 3 |
IMPORTANT:
Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
|
Go to Step 4 | Go to Power Mode Mismatch in Body Control System |
| 4 |
|
Go to Step 5 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications |
| 5 |
|
Go to Step 6 | Go to Symptoms - Engine Electrical |
| 6 | Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 7 |
| 7 | Does the scan tool display DTC B1000, B1004, B1007, or B1009? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Diagnostic Trouble Code (DTC) List |