LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2001 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Interlock Systems >> Removal & Installation >> Cluster Trim Plate Bezel >> Installation

Cluster Trim Plate Bezel: Installation

NOTE: Full seating of the trim plate bezel to the IP is crucial to the sealing of the in-car air sensor (if equipped with automatic air conditioning controls).
  1. Connect the electrical connector to the heads-up display switch if equipped.
  2. Press the instrument panel cluster trim plate bezel (2) into the IP ensuring that the clips line up with the holes in the instrument panel. See Fig 2 .
  3. Install the fasteners (1). See Fig 2 .
  4. Install the ignition cylinder bezel. See Fig 1 .
  5. Install the DIC switch. See DRIVER INFORMATION CENTER SWITCH  .
Fig 1: Removing & Installing Ignition Cylinder Bezel
G00074531Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing IP Bezel
G00074532Courtesy of GENERAL MOTORS CORP.