Test D: Retained Accessory Power Inoperative
- If Retained Accessory Power (RAP) system diagnostic system check has been performed, go to next step. If RAP system diagnostic system check has not been performed, go to RETAINED ACCESSORY POWER SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Connect scan tool to Data Link Connector (DLC). DLC is located on lower left side of instrument panel, near steering column. Close all doors. Turn ignition switch to RUN position. Wait 5 seconds, then turn ignition switch to OFF position. Operate components that have voltage supplied by RAP relay. If components do not operate, go to next step. If components operate, perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear.
- Using scan tool, observe RAP OUTPUT parameter in Rear Integration Module (RIM) data list. If RAP output indicates ON, go to next step. If RAP output does not indicate ON, go to step 11 .
- Turn ignition switch to RUN position. Using scan tool, command RAP relay on and off. If RAP relay does not turn on and off with each command, go to next step. If RAP relay turns on and off with each command, go to step 8 .
- Turn ignition switch to OFF position. Remove RAP relay from rear fuse block. See Figure . Turn ignition switch to RUN position. Connect test light between ground and RAP relay coil side feed circuit. If test light illuminates, go to next step. If test light does not illuminate, go to step 12 .
- Connect a test light between RAP relay control circuit and RAP relay coil side feed circuit at RAP relay socket. Using scan tool, command RAP relay on and off. If test light does not turn on and off with each command, go to next step. If test light turns on and off with each command, go to step 8
- Check for an open or a short to voltage in RAP relay control circuit (Black wire). If problem is not found, go to step 11 . If problem is found, repair as necessary. After repairs, go to step 15 .
- Check for an open in RAP relay output circuit (Dark Gray wire). If problem is not found, go to next step. If problem is found, repair as necessary. After repairs, go to step 15 .
- Check for an open in RAP relay load input circuit. If problem is not found, go to next step. If problem is found, repair as necessary. After repairs, go to step 15 .
- Check for poor connections/terminal tension at RAP relay socket. Perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear. If problem is not found, go to step 13 . If problem is found, repair as necessary. After repairs, go to step 15 .
- Check for poor connections/terminal tension at RIM. Perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear. If problem is not found, go to step 14 . If problem is found, repair as necessary. After repairs, go to step 15 .
- Repair RAP relay coil side feed circuit. After repairs, go to step 15 .
- Replace RAP relay. After replacement, go to step 15 .
- Replace RIM. See REAR INTEGRATION MODULE under REMOVAL & INSTALLATION.
- Operate system in order to verify repair. If system operates normally, system is okay. If system does not operate normally, go to step 1 .