Test C: Retained Accessory Power On After Time Out
- If Retained Accessory Power (RAP) system diagnostic system check has been performed, go to next step. If RAP system diagnostic system check has not been performed, go to RETAINED ACCESSORY POWER SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Connect scan tool to Data Link Connector (DLC). DLC is located on lower left side of instrument panel, near steering column. Close all doors. Turn ignition switch to RUN position. Wait 5 seconds, then turn ignition switch to OFF position. Wait 10 minutes. Operate components that have voltage supplied by RAP relay. If components operate, go to next step. If components do not operate, perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear.
- Using scan tool, observe RAP OUTPUT parameter in Rear Integration Module (RIM) data list. If RAP output indicates OFF, go to next step. If RAP output does not indicate OFF, go to step 10 .
- Turn ignition switch to RUN position. Using scan tool, command RAP relay on and off. If RAP relay does not turn on and off with each command, go to next step. If RAP relay turns on and off with each command, go to step 8 .
- Remove RAP relay from rear fuse block. See Figure . Connect a test light between RAP relay control circuit and RAP relay coil side feed circuit at RAP relay socket. Using scan tool, command RAP relay on and off. If test light does not turn on and off with each command, go to next step. If test light turns on and off with each command, go to step 8 .
- If test light remains illuminated with each command, go to next step. If test light does not remain illuminated with each command, go to step 10 .
- Check for short to ground in RAP relay control circuit. If problem is not found, go to step 10 . If problem is found, repair as necessary. After repairs, go to step 13 .
- Check for short to voltage in RAP relay load output circuit. If problem is not found, go to next step. If problem is found, repair as necessary. After repairs, go to step 13 .
- Check for poor connections/terminal tension at RAP relay. Perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear. If problem is not found, go to step 11 . If problem is found, repair as necessary. After repairs, go to step 13 .
- Check for poor connections/terminal tension at RIM harness connectors. Perform test procedure while wiggling related wiring and connectors. This can often cause an intermittent malfunction to appear. If problem is not found, go to step 12 . If problem is found, repair as necessary. After repairs, go to step 13 .
- Replace RAP relay. After replacement, go to step 13 .
- Replace RIM. See REAR INTEGRATION MODULE under REMOVAL & INSTALLATION.
- Operate system in order to verify repair. If system operates normally, system is okay. If system does not operate normally, go to step 1 .