LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2001 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Diagnostic Tests >> DTC B1009: EEPROM Checksum Error >> Testing

DTC B1009: EEPROM Checksum Error: Testing

  1. If appropriate diagnostic system check for has been performed for system exhibiting symptom, go to next step. If appropriate diagnostic system check has not been performed for system exhibiting symptom, perform appropriate diagnostic system check. See BODY CONTROL SYSTEM DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
  2. If module for system exhibiting symptom is Instrument Panel Module (IPM), go to next step. If module for system exhibiting symptom is not IPM, go to step  4 .
  3. Go to DASH INTEGRATION MODULE SET UP  , INSTRUMENT PANEL MODULE RECALIBRATION  or REAR INTEGRATION MODULE SET UP  under PROGRAMMING. Complete recalibration procedure. Using scan tool, clear DTCs. Operate vehicle within conditions for running DTC. See CODE ENABLE CRITERIA  . If DTC resets, go to step  5 . If DTC does not reset, system is okay.
  4. Connect scan tool to Data Link Connector (DLC). DLC is located on lower left side of instrument panel, near steering column. Turn ignition switch to RUN position. Retrieve DTCs. If DTC B1009 is retrieved as a current DTC, go to next step. If DTC B1009 is not retrieved as a current DTC, go to DIAGNOSTIC AIDS  .
  5. Replace appropriate module. See REMOVAL & INSTALLATION  . After replacement, go to next step.
  6. Using scan tool, clear DTCs. Operate vehicle within conditions for running DTC. See CODE ENABLE CRITERIA  . If DTC B1009 resets, go to step  2 . If DTC B1009 does not reset, system is okay.