Cruise Control Release Switch & BRAKELIGHT Switch
NOTE:
Cruise control release switch and brakelight switch must be adjusted together. Incorrect adjustment of either switch may cause premature brake lining wear or incorrect cruise control operation.
- Brake booster pushrod must be assembled to brake pedal before cruise control release switch and brakelight switch can be adjusted. With brake pedal released, switch plunger should be fully depressed against brake pedal shank. To adjust, depress brake pedal and push switch until switch body is fully seated in retainer. Pull brake pedal toward rear of vehicle, against pedal stop (until clicking sound cannot be heard while pulling pedal). Switch will adjust to proper position in retainer.
- Measure brake pedal travel from centerline of brake pedal and ensure switch contacts are open at 1/8-1/2" (3.5-12.5 mm) of pedal travel. Nominal actuation of brake switch contacts is about 3/16" (4.5 mm) after cruise control release switch contacts close. Check brakelights for proper operation.