Diagnostic Procedures
- Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK . After performing OBD system check, go to next step.
- Turn ignition on. Using scan tool, check DTCs. If DTC P1676 is set, diagnose DTC P1676 first. If DTC P1676 is not set, go to next step.
- Turn ignition off. Disconnect cruise control module connector. Turn ignition on. Using a DVOM, check voltage between engine ground and cruise status circuit at cruise control module connector. If voltage reading is about battery voltage (greater than 7 volts on Monte Carlo and Regal), go to next step. If voltage reading is not about battery voltage (greater than 7 volts on Monte Carlo and Regal), go to step 5.
- Turn ignition off. Reconnect cruise control module connector. Turn ignition on. Using test light connected to battery voltage, probe cruise control engaged status circuit at PCM connector. If test light illuminates, go to step 6. If test light does not illuminate, go to step 7.
- Turn ignition off. Disconnect PCM harness connector. Connect test light between battery voltage and cruise engaged status circuit at PCM connector. If test light illuminates, go to step 8. If test light does not illuminate, go to step 7.
- Replace cruise control module. After replacing module, go to step 9.
- Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to step 9.
- Locate and repair short to ground in cruise engaged status circuit. After repairs, go to next step.
- Clear DTCs. Start engine and read DTCs. If DTC P1554 resets, return to step 2. If DTC does not reset, repair is complete.