LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1989 >> Skyhawk S/E, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L(K)/2.5L Tests W/Codes >> Description >> Chart C1A - Park/Neutral Switch

Chart C1A - Park/Neutral Switch

The Park/Neutral switch contacts are part of neutral start switch and are closed to ground in Park or Neutral, and open in Drive ranges. The ECM supplies ignition voltage through a current limiting resistor to circuit No. 434, and senses a closed switch when voltage on circuit No. 434 drops to less than one volt. The ECM uses this signal as one of the inputs to control IAC and VSS diagnostics.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Checks for closed switch to ground in Park position. Different makes of "Scan" tester will read P/N differently. Refer to manufacturer's operating manual for type of display used.
  2. Checks for an open switch in Drive range.
  3. Be sure "Scan" tester indicates Drive. Wiggle shifter to test for an intermittent or misadjusted switch.
Fig 1: Chart C1A Schematic, Park/Neutral Switch
G110349
Fig 2: Flow Chart C1A, Park/Neutral Switch
G110350