LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1989 >> Skyhawk S/E, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L(K)/2.5L Tests W/Codes >> Description >> Chart A2 - No Code 12, "SES" Light Always On

Chart A2 - No Code 12, "SES" Light Always On

The "SERVICE ENGINE SOON" light should come on when ignition switch is in the "ON" position and engine is not running. With diagnostic terminal grounded, light should flash Code 12, followed by other trouble codes stored in memory. A steady light indicates a grounded circuit No. 419 or an open diagnostic circuit No. 451.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. If "Scan" tester is not operating, check on another vehicle. If okay, check circuit No. 461. The cigarette lighter socket should also be checked for 12 volts and a good ground. If all is okay, ECM or PROM is faulty.
  2. If the light goes off when the ECM connector is disconnected, then circuit No. 419 is not shorted to ground. Check connector terminals physically for proper contact.
  3. This step checks for an open diagnostic circuit No. 451.
  4. At this point "SERVICE ENGINE SOON" light wiring is okay. Problem may be a faulty ECM or PROM. If Code 12 does not flash, the ECM should be replaced using the original PROM. Replace the PROM only after trying a new ECM, as a defective PROM is an unlikely cause of the problem.
Fig 1: Chart A2, No Code 12 Schematic, "SES" Always On (Exc. 2.5L A Body)
G112001
Fig 2: Chart A2, No Code 12 Schematic, "SES" Always On (2.5L A Body)
G110299
Fig 3: Flow Chart A2, No Code 12 "SES" Light Always On (All)
G110300