LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1989 >> Skyhawk S/E, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L VIN [1] Tests W/Codes >> Diagnosis & Testing >> Chart C2C, Idle Air Control >> Notes

Chart C2C, Idle Air Control: Notes

Fig 1: Chart C2C Schematic, Idle Air Control "J" Body
G50G08315
Fig 2: Chart C2C Schematic, Idle Air Control "L" Body
G50I08316
Fig 3: C2C Flow Chart, Idle Air Control "L" Body
G50A08317
NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Continue with test, even if engine will not idle. If idle speed is too low, "Scan" tester will display 90 or more counts, or steps. If idle is high, it will display zero counts. Occasionally an erratic or unstable idle may occur. Engine speed may vary 200 RPM or more up and down. Disconnect IAC. If the condition is unchanged, the IAC is not at fault.
  2. When the engine was stopped, the IAC plunger retracted (more air) to a fixed "park" position for increased airflow and idle speed during the next engine start. A "Scan" tester will display 100 or more counts.
  3. Be sure to disconnect the IAC valve prior to this test. The test light will confirm the ECM signals by a steady or flashing light on all circuits.
  4. There is a remote possibility that one of the circuits is shorted to voltage, which would have been indicated by a steady light. Disconnect ECM and turn the ignition on. Probe terminals to check for this condition.