LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 1989 >> Skyhawk S/E, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L VIN [1] Tests W/Codes >> Diagnosis & Testing >> Chart C1D, Map Output Check

Chart C1D, Map Output Check

Fig 1: Chart C1D, Flow Chart (1 of 2) - Map Output Check
G110434
Fig 2: Chart C1D, Flow Chart (2 of 2) - Map Output Check
G110435
  1. Checks MAP sensor output voltage to the ECM. This voltage, without engine running, represents a barometer reading to the ECM.
  2. Applying 10 in. Hg (34 kPa) vacuum to the MAP sensor should cause the voltage to be 1.2-2.3 volts less than the voltage at test 1). When applying vacuum to the sensor, the change in voltage should be instantaneous. A slow voltage change indicates a faulty sensor.
  3. Check vacuum hose to sensor for leaking air restriction. Be sure no other vacuum devices are on or connected to the MAP hose.

The power steering pressure switch is normally open to ground, and circuit No. 495 will be near battery voltage. Turning the steering wheel increases power steering oil pressure and its load on an idling engine. The pressure switch will close before the load can cause an idle problem. Closing the switch causes circuit No. 495 to read less than one volt and the ECM will increase the idle air rate and de-energize the A/C relay.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Different makes of "Scan" testers may display the state of this switch in different ways. Refer to "Scan" tester operating manual to determine how this input is indicated.
  2. Checks to determine if circuit No. 495 is shorted to ground.
  3. This should simulate a closed switch.