LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> i3 Base >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Accessories Control Systems >> SME Fault Code 21F0D2 (SI B61 10 17)

SME Fault Code 21F0D2 (SI B61 10 17)

Publication date: 2017-03-01
Reference number: SI B61 10 17

SME FAULT CODE 21F0D2

SME FAULT CODE 21F0D2

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B61 10 17, Date of Issue:  March 2017
BMW: I01 94Ah (i3 & i3 REx)
GROUP: General Electrical Systems

SITUATION

The following Check Control message (CCM) was displayed to the customer:

CAUSE

Erroneous fault or hardware defect in the safety box (S-Box).

CORRECTION

Clear fault memory or diagnose with ISTA.

PROCEDURE

For conditions that are similar to the situation described:

  1. Read out the fault memory of the vehicle with ISTA and check whether the following fault code is stored in the fault memory of the battery management electronics (SME):
    • 21F0D2 - High-voltage battery unit, negative terminal: Switching contactor, contact stuck closed
      NOTE: The following fault code may also be entered:
    • 21F153 - High-voltage battery, safety concept 2: Safety circuit to switch off the switch contactors, switch-off detected

    Was fault code 21F0D2 stored in the SME memory? 

    YES - Go to Step 2.

    NO - continue diagnosis with ISTA.

  2. Delete the fault memory and allow the vehicle to go to sleep.
  3. Read out the fault memory again.

    Was the fault code 21F0D2 reentered? 

    YES - continue diagnosis with ISTA. In most cases ISTA will recommend an S-Box replacement.

    NO - This is an erroneous fault and can be ignored.

    NOTE: Work on a solution is currently in progress. When the solution is available, this service information bulletin will be updated accordingly.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks.

Defect Code: 6127050200
Labor Operation: Labor Allowance: Description:
00 00 006 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Main work)
Or:
00 00 556 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Plus work)
And:
61 25 910 Refer to KSD2 Recharging high-voltage battery unit (to high voltage charging unit)

If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.

Other Repairs

If other work is performed as a result of performing the ISTA diagnostics and related test plans:

  • When covered under an applicable limited warranty, claim the control module-related and/or other repair work using the applicable defect code and labor operations in KSD2/AIR.