LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 528i >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Engine Control Systems >> N52T Engine: Intermittent Noise From Engine (11 03 12)

N52T Engine: Intermittent Noise From Engine (11 03 12)

Publication date: 2012-03-09
Reference number: 11 03 12

N52T ENGINE: INTERMITTENT NOISE FROM ENGINE

N52T ENGINE: INTERMITTENT NOISE FROM ENGINE

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B11 03 12, Date of Issue:  March 2012
BMW: F10 (5 Series) 528i with N52T engine from start of production to September 31st, 2011; F25 (X3) xDrive28i with N52T engine from start of production to March 1st, 2012
GROUP: Engine

SUBJECT

N52T Engine: Intermittent Noise from Engine 

SITUATION

The customer complains that a slight rattling noise can be heard from the upper portion of the engine while idling. The rattling noise occurs after a cold start-up and may continue for a few minutes while the engine temperature increases. As the engine temperature increases, the rattling noise will diminish.

CAUSE

A DME software error is affecting the cold start operation of the engine oil pump volume control solenoid.

PROCEDURE

Compare the vehicle's current I-Level data status to the chart below. If the vehicle has a lower I-Level data status, program the vehicle using ISTA/P 2.43.0. or later.

Model: Integration Level:
F10 with N52T engine F010-12-03-510
F25 with N52T engine F025-12-03-502
NOTE: When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the displayed battery voltage reading in the repair order comments section.

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

For information on programming and coding with ISTA/P, refer to Centernet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle/SAV Limited Warranty or the BMW Certified Pre-Owned Limited Warranty.

Defect Code:  11 41 09 29 00 
Labor Operation: Labor Allowance: Description:
00 00 006 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults)
and if necessary, also
61 21 528 Refer to KSD2 Charging battery
and
61 00 730 Refer to KSD2 Programming / encoding control unit(s)

Labor operation code 00 00 006 is a Main labor operation. If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in the FR code field.

If a control module fails to program correctly or initializations are required, the additional work must be claimed with separate labor operations under the defect code listed above, refer to KSD2.

Other Repairs - Vehicles Already at or above the Listed Integration Level

If performing the ISTA diagnostics and related test plans results with other eligible  and covered work, claim this work with the applicable defect code and labor operations listed in KSD2.