LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335d >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Accessories Control Systems >> Buttons On The IDRIVE Controller Not Working (61 09 11)

Buttons On The IDRIVE Controller Not Working (61 09 11)

Publication date: 2011-06-15
Reference number: 61 09 11

BUTTONS ON THE IDRIVE CONTROLLER NOT WORKING

BUTTONS ON THE IDRIVE CONTROLLER NOT WORKING

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI B61 09 11, Date of Issue:  June 2011
BMW: E82, E88 (1 Series); E89 (Z4); E90, E91, E92, E93 (3 Series); E70 (X5); E71 (X6); All equipped with the iDrive controller; Vehicles produced from August 31, 2004
GROUP: General Electrical Systems

SUBJECT

Buttons on the iDrive Controller Not Working 

SITUATION

The buttons on the iDrive controller are not working.

CAUSE

The button(s) on the iDrive controller mechanically stick.

PROCEDURE

Do not replace parts for the situation described in this Service Information bulletin.

  1. Remove the controller from the center console (electrical connection still connected), and retest the operation of all the buttons.
  2. If the buttons work properly when the controller is removed, reinstall the controller in the center console. Ensure that the controller is fitted properly into the center console, without any tension. Retest the button operation. If the buttons still do not work properly, proceed to procedure steps 3 and 4.
  3. Perform diagnosis using ISTA (Integrated Service Technical Application). Complete any test plans related to iDrive controller faults, if stored.
  4. If no faults are stored, perform and follow the recommendations in the "CON: Control button and additional buttons" test plan. The test plan can be found under the following path: "Function structure / Body / Operation / Contoller / Control knob and additional buttons  ".

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle/SAV Limited Warranty.

Procedure Steps 1 and 2 

Defect Code:  61 31 68 83 00 - Procedure Steps 1 and 2 (to be used for steps 1 and 2 only)

WARRANTY INFORMATION

Labor Operation: Labor Allowance: Description:
61 31 195 Refer to KSD2 Removing and installing front controller (Main work)

Labor operation code 61 31 195 is a main labor operation, if you are using a main labor code for another repair; use the plus code labor operation 61 31 695 instead.

Procedure Steps 3 and 4 

Defect Code:  Refer to KSD2 - Procedure Steps 3 and 4 (See below)

WARRANTY INFORMATION

Labor Operation: Labor Allowance: Description:
00 00 556 Refer to KSD2 Performing vehicle test (Plus work)
and
61 00 006* Work time (WT) Performing vehicle diagnosis - test module

If procedure steps 3 and 4 are required, refer to the KSD2 to flat rate and defect code the repairs performed as prescribed by ISTA diagnosis results and combine with the repair for steps 1 and 2 under this defect code.

Only one main labor operation can be claimed per repair visit. All other labor operations on the same line or other lines must be claimed using plus code labor operations.

*The amount of FRUs claimed for a work time labor operation must be documented by an individual punch time to support the time that was necessary to perform the required repair. Even though work time (WT) labor operation code 61 00 006 ends in "006", as it is used in the above repair procedure, this labor operation is not considered a main labor operation.

Please refer to the Warranty Policy and Procedures Manual regarding proper support, documentation and archiving required for claims, as applicable.