LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2007 >> 550i Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> General Electrical System - Repair >> 31 Switch >> 61 31 382 Replacing Level Switch For Coolant

61 31 382 Replacing Level Switch For Coolant

WARNING:

Danger of scalding!

Only perform this work after engine has cooled down.

Release screws (1).

Unlock plug connection for coolant level switch (4) and disconnect.

Pull coolant expansion tank (2) in direction of arrow out of grommet (3) underneath.

Installation: 

Make sure coolant expansion tank (2) is correctly seated in grommet (3).

If necessary, replace grommet (3).

IMPORTANT:

Do not damage connected water hoses.

Reposition coolant expansion tank (2) as far as possible until coolant level switch (4) forms the highest point. This will prevent coolant from escaping on opening.

If necessary, catch escaping coolant and feed back in later.

Fig 1: Pulling Coolant Expansion Tank And Grommet
G04957631Courtesy of BMW OF NORTH AMERICA, INC.
NOTE:

For purposes of clarity, illustration shows coolant expansion tank (2) removed.

Turn coolant level switch (1) in direction of arrow, pull upwards out of coolant expansion tank (2) and remove.

Fig 2: Turning Coolant Level Switch
G04957632Courtesy of BMW OF NORTH AMERICA, INC.