Disassembly & Assembly
- Remove starter solenoid. Unscrew and remove dust cap. Remove retainer, shim, and sealing ring. To install, check end float of armature. If necessary, correct with shims. Remove housing screws and cover. To install, recesses for housing screws and insulating section must fit with one another. Check and lubricate bearings/bushings before installation.
- Lift spring and remove carbon brushes. Remove retaining plate. To install, check carbon brushes and connector for wear and repair if necessary. Remove terminal housing. Remove screw for engagement lever and remove rubber seal. Lift out armature with drive pinion and selector fork. To install, grease guide for selector fork. Check bearing bush on input bearing plate and lubricate prior to installation.
- Press back thrust ring with suitable tube section. Press retaining rings apart and pull off shaft. Remove burr with file and remove drive pinion. To install, use new retaining ring. Grease race for drive pinion. To install, check pinion for signs of wear (wear on gears/splines, bearings, freewheels) and replace if necessary. Check bushing in intermediate bearing and replace if necessary.
Courtesy of BMW OF NORTH AMERICA, INC.