LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 1983 >> 528e Standard >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly >> Installation

Clutch Assembly: Installation

  1. Using alignment tool, install clutch disc and pressure plate. Install flywheel holding tool. Tighten pressure plate mount bolts evenly, in diagonal pattern. On all except 318i & 320i, install clutch housing.
  2. Lightly apply molybdenum grease on contact surfaces of release bearing, disc hub splines, pressure plate and release lever. Install slave cylinder with bleeder screw at bottom.
  3. Install drive shaft. To preload center bearing, move bracket .078" (2 mm) forward in slots. Install and tighten NEW drive shaft flange lock nuts. On 320i, install clutch housing. To complete installation, reverse removal procedure.