Steering Intermediate Shaft, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
- Replace bolt after removal.
- Clean the threaded hole for the bolt on the universal joint with for example a thread tap.
-- Bring the steering intermediate shaft -2- into the installation position at the same time the sealing lip -1- must contact the insulation, as shown.
- The -arrow- points upward.
-- Tighten the bolt -3- and the nuts -4- (shown on a LHD vehicle).
-- Push the intermediate shaft universal joint -2- all the way on the steering column -3-.
-- Install the bolt -1- first by hand in the first threads. Check if the steering intermediate shaft is seated correctly by pulling. Tighten the bolt.
-- Repeat the procedure on the lower universal joint to the steering gear.
-- Connect to the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .