LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> A5 Sportback Prestige >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition/Glow Plug System Servicing (2.0L) >> 28 Ignition/Glow Plug System >> Ignition System >> Ignition Coils, Removing And Installing >> Removing

Ignition Coils, Removing And Installing: Removing

Depending on the model, preliminary work may be required. Refer to the appropriate service information. .

-- If installed, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the connector -1- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- -2- from the bracket.

GWWA24-10925Courtesy of AUDI OF AMERICA, LLC

Tip:

Different installation positions depending on models and version.

-- If equipped, remove the nut -2- and free up the ground wire -1-.

GWWA28-10148Courtesy of AUDI OF AMERICA, LLC

-- Release the connectors and simultaneously disconnect them from the ignition coils in direction of -arrows-.

-- Remove the corresponding double bolt -3-.

-- Insert :T10530  in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530
GWWN28-10134Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise in direction of -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically in direction of -arrow- using :T10530  .

Fig 2: Identifying Puller T10530
GWWN28-10135Courtesy of AUDI OF AMERICA, LLC