Self-Leveling Compressor Inoperative (GROUP 43, NO. 13-2)
Publication date: 2013-09-16Reference number: GROUP 43, NO. 13-2
Supersedes refnos: 2018765, GROUP 43, NO. 08-13, GROUP 43, NO. 08-16, GROUP 43, NO. 09-10, GROUP 43, NO. 10-01, GROUP 43, NO. 12-08, GROUP 43, NO. 12-11, GROUP 43, NO. 13-14
SELF-LEVELING COMPRESSOR INOPERATIVE
TECHNICAL SERVICE BULLETIN
| AUDI: | A6 (C6) 2006 - 2008; A8 (D3) 2004 - 2010; Q7 2007 - 2012; S6 (C7) 2013; S7 (C7) 2013; A8 (D4) 2011 - 2013 |
| GROUP: | 43 - Self-Leveling Suspension |
43 13 23 2018765/9 September 16, 2013. Supersedes Technical Service Bulletin Group 43 number 13-14 dated April 11, 2013.
| Model(s) | Year | VIN Range | Vehicle-Specific Equipment |
|---|---|---|---|
| A6 (C6) | 2006 - 2008 | All | Air Suspension |
| A8 (D3) | 2004 - 2010 | All | Air Suspension |
| Q7 | 2007 - 2012 | All | Air Suspension |
| S6 (C7) | 2013 | All | Air Suspension |
| S7 (C7) | 2013 | All | Air Suspension |
| A8 (D4) | 2011 - 2013 | All | Air Suspension |
CONDITION
- The self-leveling system can no longer be adjusted with the MMI.
- The compressor for the self-leveling system continues to run after the engine has been switched off and the vehicle has been locked.
- One of the following DTCs may be stored in the level control system module, J197 (address word 34):
- DTC 0453 (restricted function through excess temperature)
- DTC 1583 (leak in the system recognized)
- DTC 1770 (sender for compressor temperature of self-leveling control G290)
- DTC 1772 (signal cable of pressure sender for self-leveling control G291)
- DTC 2645 (valves for self-leveling control)
- DTC 2646 (plausibility of self-leveling control)
TECHNICAL BACKGROUND
Because of poor performance or failure of the air suspension compressor, the vehicle ride height cannot be adjusted. As a safeguard, the control module will lower the vehicle to the lowest position and illuminate the warning light. Driveability is not affected.
PRODUCTION SOLUTION
Not applicable.
SERVICE
Tip: See the current flow diagram for the location of the J403 relay for the air supply unit and the location of the air compressor (air supply unit).
- Check the function of the air compressor by supplying it with direct current. Determine if the air compressor is operating correctly and sounds normal, if it is unusually noisy, or if it is not working at all.
- Check relay J403 by opening the relay and comparing it to the images below:
If the relay exhibits any of the conditions A - C below, replace both the air compressor and the relay, even if the air compressor sounds normal.
- Strong erosion of both contacts (Figure 1, Figure 2).
- Strong erosion of the spring contact (Figure 3).
- Overheated strand (Figure 4).
If the relay contacts are similar to condition D below, and the air compressor sounds normal, replace only the relay.
- Contacts with minor marks (Figure 5).NOTE: When replacing both the compressor and relay, attach/secure the relay to the compressor and mark both components with the VIN.
- Strong erosion of both contacts (Figure 1, Figure 2).
WARRANTY
| Claim Type: | Use applicable claim type. Vehicle may be outside any warranty, in which case this Technical Service Bulletin is informational only. | ||
| Service Number: | 4315 | ||
| Damage Code: | 0040 | ||
| Labor Operations: | A6 (C6) (2005 - 2008): | ||
| Compressor remove and install | 4315 1950 | 70 TU | |
| Front bumper cover remove and install | 6329 1900 | 90 TU | |
| Central electronics cover remove and install | 9793 1900 | 70 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 10 TU | |
| A8 V8 (D3) (2004 - 2010): | |||
| Compressor remove and install | 4315 1900 | 90 TU | |
| Shelf under dash panel remove and install | 6818 1900 | 50 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 10 TU | |
| S8 and W12 (D3) (2005 - 2010): | |||
| Compressor remove and install | 4315 1950 | 70 TU | |
| Lock carrier loosened and fastened | 5038 0900 | 160 TU | |
| Shelf under dash panel remove and install | 6818 1900 | 50 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 10 TU | |
| Vehicle front & rear measure (cars with ACC only) | 4495 0300 | 90 TU | |
| Radar sensor check & adjust (cars with ACC only) | 9163 1550 | 30 TU | |
| Radar sensor adjust (cars with ACC only) | 9163 0550 | 30 TU | |
| Audi Q7 (2007 - 2012): | |||
| Compressor remove and install | 4315 1900 | 70 TU | |
| Shelf under dash panel remove and install | 6818 1900 | 30 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 10 TU | |
| A8 (D4) (2011 - 2013) | |||
| Compressor remove and install | 4315 1900 | 50 TU | |
| Shelf under dash panel remove and install | 6818 1900 | 30 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 10 TU | |
| S6 / S7 (C7) (2013): | |||
| Compressor remove and install | 4315 1900 | 50 TU | |
| Relay for suspension compressor inspect | 4315 1999 | 20 TU | |
| Diagnostic Time: | GFF | 0150 0000 | Time stated on diagnostic protocol (MAX 50 TU) |
| Road test prior to service procedure | No allowance | 0 TU | |
| Road test after service procedure | No allowance | 0 TU | |
| Technical diagnosis at dealer's discretion (Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details) |
|||
| Claim Comment: | As per TSB #2018765/9 | ||
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual . Claims are subject to review or audit by Audi Warranty.
ADDITIONAL INFORMATION
All parts and service references provided in this TSB (2018765) are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.