Automatic Transmission
Turn ignition off. Remove clip from outer throttle cable notched sleeve. Fully depress throttle to Wide Open Throttle (WOT). Move throttle cable outer sleeve in or out of grommet as necessary until WOT is reached and kick-down switch audibly clicks. See Figure and Figure . Reinstall clip onto first completely exposed notch closest to grommet. Check closed and wide open throttle stops. After adjustment check kick-down switch operation. Disconnect kick-down switch 2-pin harness connector. Kick-down switch is located on firewall, above accelerator cable. Using DVOM, measure resistance between kick-down switch harness connector terminals No. 1 and 2. See Figure . With throttle closed resistance should be infinity. Slowly press accelerator pedal to floor. Shortly after kick-down point, resistance should change to zero ohms. Accelerator pedal should be close to full throttle. If kick-down switch does not operate as specified, replace cable.