Removal & Installation
NOTE:
DO NOT kink control cable. If control cable is kinked, gear selector may not move.
- Move shifter to "2" position. Disconnect negative battery cable and wait 30 seconds. Remove shifter handle. Remove center console. Disconnect voltage supply connector for air bag. Using Torx wrench, remove air bag retaining screws from rear side of steering wheel. Remove air bag. Remove steering wheel.
- Remove instrument cluster. Turn ignition on. Place gear selector in Park position. Lift locking clip and pull locking cable from ignition switch. Remove shifter cover. Lift spring clip holding cable housing to shifter assembly. Remove cable from shifter. Remove cable from cable tie at base of instrument panel. To install cable housing, reverse removal procedure. Adjust control cable. See IGNITION INTERLOCK CABLE procedure under ADJUSTMENTS.