LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1995 >> 90 Base, 2.8 A, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Engine Sensors & Switches >> Mass Airflow (MAF) Sensor

Mass Airflow (MAF) Sensor

  1. Ensure circuit breaker is okay. Disconnect MAF sensor connector. See ELECTRICAL COMPONENT LOCATIONS  . Turn ignition on. Measure voltage between MAF sensor connector terminals No. 2 and 3. See Fig 1 . If battery voltage is not present, check for faulty wiring.
  2. If battery voltage is present, check wiring between MAF sensor and PCM. If wiring is okay, push back protective boot on MAF sensor connector. Turn ignition on.
  3. Measure voltage between MAF sensor connector terminals No. 1 and 2. If 0.3-1.1 volts is not present, replace MAF sensor. If 0.3-1.1 volts is present, start engine.
  4. Turn off all electrical accessories. Ensure radiator cooling fan is not running. Vary engine speed between idle and 4000 RPM while measuring voltage between terminals No. 1 and 2. If 1.5-3.4 volts is present, system is okay. If 1.5-3.4 volts is not present, replace MAF sensor.
Fig 1: Identifying MAF Sensor Connector Terminals (90)
G91I16541Courtesy of AUDI OF AMERICA, INC.
NOTE: TP sensor is automatically adjusted when TP switch is adjusted.