LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 1995 >> 90 Base, 2.8 A, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Engine Sensors & Switches >> Camshaft Position (CMP) Sensor

Camshaft Position (CMP) Sensor

  1. Disconnect CMP sensor connector. See ELECTRICAL COMPONENT LOCATIONS  . Connect Test Box (VAG 1598) to PCM with Adapter Cable (VAG 1598/11). Connect LED Tester (1115) between test box terminals No. 8 and 46. Operate starter for several seconds.
  2. If LED flashes at each second engine revolution, go to next step. If LED does not flash at each second engine revolution, check for faulty wiring. If wiring is okay, go to next step.
  3. Turn ignition on. Check voltage between test box terminals No. 7 and 45. If 9 volts minimum is not present, replace PCM. If 9 volts minimum is present, check voltage between test box terminals No. 8 and 45. If 4 volts minimum is not present, replace PCM. If 4 volts minimum is present, replace CMP sensor.
NOTE: CTP switch is part of TP sensor.