EGR Control Solenoid Valve
- Disconnect harness connector from EGR control solenoid valve. See ELECTRICAL COMPONENT LOCATIONS . Measure resistance across EGR control solenoid valve terminals. See Figure . If resistance is not 25-35 ohms, replace EGR control solenoid valve.
- If resistance is 25-35 ohms, connect LED Tester (US 1115) between engine ground and EGR control solenoid valve connector terminal No. 1 with jumper from Adaptor Kit (VW 1594). Operate starter for several seconds. If LED does not come on, check circuit breaker, wiring and fuel pump relay.
- If LED comes on, connect LED tester between EGR control solenoid valve connector terminals with jumper from adaptor kit. In self-diagnostics mode, initiate Output Diagnostic Test Mode (Output DTM). LED tester should flash when Output DTM is initiated for EGR control solenoid valve.
- If LED flashes as specified, system is okay. If LED does not flash as specified, check wiring harness. If wiring harness is okay, replace PCM.