LEMON Manuals: Even more car manuals for everyone
Home >> Alfa Romeo >> 2019 >> 4C >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Delivery >> Tank, Fuel >> Removal And Installation

Removal And Installation

REMOVAL 

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect the negative battery terminal.
  3. Remove the engine bellypan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
  4. Remove the rear belly pan. Refer to BELLY PAN, REAR, REMOVAL AND INSTALLATION .
  5. Remove the insulating panel for engine compartment/fuel tank partition. Refer to SHIELD, HEAT, REMOVAL AND INSTALLATION .
  6. Draw off the fuel from the tank using suitable equipment.
    GC0167908Courtesy of CHRYSLER GROUP, LLC
  7. Undo the fixing screws (1a) and remove the rear crossmember (1b).
    GC0166792Courtesy of CHRYSLER GROUP, LLC
  8. Position a suitable hydraulic lift underneath the fuel tank.
  9. Undo the fixing screws securing the fuel tank retaining bands.
    GC0167900Courtesy of CHRYSLER GROUP, LLC
  10. Undo the fixing screws (1a) and remove the panel-oddments pocket (1b).
    GC0166956Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect the electrical connection for the fuel pump.
  12. Adjust the quick coupling and disconnect the fuel supply pipe.
  13. Adjust the quick coupling and disconnect the pipe for the emission control system.
  14. Adjust the quick coupling and disconnect the fuel vapour bleed pipe.
  15. Slowly lower the hydraulic lift until the fuel reservoir comes out from its housing.
  16. If necessary, remove the fuel pump module. Refer to MODULE, FUEL PUMP, REMOVAL AND INSTALLATION .

INSTALLATION 

  1. If removed, install the fuel pump module. Refer to MODULE, FUEL PUMP, REMOVAL AND INSTALLATION .
  2. Place the fuel tank in position.
  3. Connect the electrical connection for the submerged pump.
  4. Adjust the quick coupling and connect the fuel supply pipe.
  5. Adjust the quick coupling and connect the pipe for the evaporation control system.
  6. Adjust the quick coupling and connect the fuel vapour bleed pipe.
    GC0167232Courtesy of CHRYSLER GROUP, LLC
  7. Extrude a strip of sealant along the perimeter of the panel-oddments pocket, in the area shown in the illustration.
  8. Reposition the panel-oddments pocket in its housing and tighten the fixing screws.
    GC0167625Courtesy of CHRYSLER GROUP, LLC
  9. Tighten the fixing screws securing the fuel tank retaining bands.
    Component Fixing Ø Value (daNm)
    Fuel reservoir retaining band Screw M8x30 3.2 ÷ 3.9
  10. Remove the hydraulic lift from underneath the fuel tank.
    GC0167475Courtesy of CHRYSLER GROUP, LLC
  11. Reposition the lower rear crossmembers (1a) and tighten the fixing screws (1b).
    Component Fixing Ø Value (daNm)
    Rear frame Screw M10 5.2 ÷ 5.8
  12. Remove the hydraulic lift from underneath the reservoir.
  13. Install the insulating panel for engine compartment/fuel tank partition. Refer to SHIELD, HEAT, REMOVAL AND INSTALLATION .
  14. Install the rear belly pan. Refer to BELLY PAN, REAR, REMOVAL AND INSTALLATION .
  15. Install the engine bellypan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
  16. Connect the negative battery terminal.
  17. Remove the vehicle from the hoist.