Confirmation Procedure
Perform the following procedures in order. If the failure is duplicated, the confirmation procedure is completed.
- Procedure 1
-
- Start the engine.
- Hold the engine speed at 3, 00 rpm without load (in P or N) until the radiator fan comes on, then let it idle at least 8 seconds.
- Procedure 2
-
- Test-drive the vehicle for several minutes in the same range of the recorded on-board snapshot parameters shown below:
Engine Speed
Vehicle Speed
REL TP Sensor
CLV (calculated load value)
APP Sensor
- Monitor the HDS [OBD STATUS (PGM-FI)] for DTC P0236.
- Test-drive the vehicle for several minutes in the same range of the recorded on-board snapshot parameters shown below: