DTC Troubleshooting: P0193 (3.0L Engine): Inspection
Fuel Rail Pressure Sensor Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Unit output voltage inspection
- Preparation
-
- -
Fuel rail pressure sensor 3P connector: disconnected
- -
- Procedure
-
- Jump the fuel rail pressure sensor 3P connector terminals No. 1 and No. 2 with a jumper wire.
- Turn the vehicle to the ON mode.
- Confirm the HDS [Fuel Pressure Converted From PF Sensor Voltage].
| (Disconnected) Fuel rail pressure sensor 3P connectorfemale terminals | |
|
|
- Normal Conditions
-
- -
USA and Canada models: HDS [Fuel Pressure Converted From PF Sensor Voltage] value is less than 4.83 V .
- -
Mexico models: HDS [Fuel Pressure Converted From PF Sensor Voltage] value is less than 4.87 V .
- -
Results
- If it is normal, there is a problem with the fuel rail pressure sensor.
- If it is abnormal, there is a problem with other related components.
PF, SG1 Open Wire Inspection
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
Test Procedure
- Preparation
-
- -
Fuel rail pressure sensor 3P connector: disconnected
- -
PCM connector E (114P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
- -
| (Disconnected) Fuel rail pressure sensor 3P connectorfemale terminals | (Disconnected) PCM connector E (114P) - Refer to: PCM Connector for Inputs and Outputs(3.0L Engine) or PCM Connector for Inputs and Outputs(2.0L Engine) female terminals | ||||
| IG Mode |
|
|
Normal Conditions | ||
| PF open wire inspection | OFF | There is less than 1 Ohm | |||
| SG1 open wire inspection | OFF | There is less than 1 Ohm | |||
Results
- If it is abnormal, there is a problem in the circuit.
PCM Inspection
Test Procedure
- If the other inspection item(s) indicated a normal condition, then it is determined that the remaining PCM is the cause.
Results
- There is a problem with the PCM.