DTC Troubleshooting: P0138 (3.0L Engine): Inspection
SO2, SO2SG Shorted Wire Inspection
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
Test Procedure
- Preparation
-
- -
Secondary HO2S (Sensor 2) 4P connector: disconnected
- -
PCM connector E (114P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.
- -
| (Disconnected)Secondary HO2S (Sensor 2) 4P connectormale terminals | ||||
| IG Mode |
|
Normal Conditions | ||
| SO2 shorted to power inspection | ON | Not shorted | ||
| SO2SG shorted to power inspection | ON | Not shorted |
Results
- If abnormal, there is a problem in the circuit.
Secondary HO2S (Sensor 2) Inspection
NOTE:
Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.
Test Procedure
- Install a known-good secondary HO2S (Sensor 2) and attempt to reproduce the failure.
Results
- If the failure is reproduced, there is a problem with other related components.
- If the symptom/DTC goes away, the secondary HO2S (Sensor 2) must be faulty.
PCM Inspection
Test Procedure
- If the other inspection item(s) indicated a normal condition, then it is determined that the remaining PCM is the cause.
Results
- There is a problem with the PCM.