DTC Troubleshooting: P0137 (3.0L Engine): Inspection
SO2, SO2SG Circuit Inspection
NOTICE:
Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.
Test Procedure
- Preparation
-
- -
Secondary HO2S (Sensor 2) 4P connector: disconnected
- -
PCM connector E (114P): disconnected
- -
- Procedure
-
- -
Perform the inspection according to the following table.
- -
| (Disconnected)Secondary HO2S (Sensor 2) 4P connectormale terminals | (Disconnected) PCM connector E (114P) - Refer to: PCM Connector for Inputs and Outputs(3.0L Engine) or PCM Connector for Inputs and Outputs(2.0L Engine) female terminals | ||||
| IG Mode |
|
|
Normal Conditions | ||
| SO2 open wire inspection | OFF | There is less than 1 Ohm | |||
| SO2SG open wire inspection | OFF | There is less than 1 Ohm | |||
| SO2 shorted to ground inspection | OFF | Not shorted | |||
| SO2SG shorted to ground inspection | OFF | Not shorted | |||
Results
- If abnormal, there is a problem in the circuit.
Secondary HO2S (Sensor 2) Inspection
NOTE:
Since there is no direct method to test the inspection item, troubleshooting is performed using a known-good component.
Test Procedure
- Install a known-good secondary HO2S (Sensor 2) and attempt to reproduce the failure.
Results
- If the failure is reproduced, there is a problem with other related components.
- If the symptom/DTC goes away, the secondary HO2S (Sensor 2) must be faulty.
PCM Inspection
Test Procedure
- If the other inspection item(s) indicated a normal condition, then it is determined that the remaining PCM is the cause.
Results
- There is a problem with the PCM.