Transmission Range Switch Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Transmission range switch signal input inspection
- Preparation
-
- -
Transmission range switch connector (10P): disconnected
- -
- Procedure
-
- Connect the transmission range switch connector terminal that did not indicate ON in confirmation procedure to ground with a jumper wire.
- Turn the vehicle to the ON mode.
- Check the transmission range switch signal that did not indicate ON with the HDS.
(Disconnected) Transmission range switch connector (10P) female terminals
- Normal Conditions
-
- -
The transmission range switch signal indicates "ON".
- -
Results
- If it is normal, there is a problem with the transmission range switch.
- If it is abnormal, there is a problem with other related components.