Throttle Body Removal and Installation: Installation
Do not insert your fingers into the installed throttle body when you press the engine start/stop button to select the ON mode, or while the vehicle is in the ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.
- Throttle Body - Install
1. Install the throttle body (A) with a new gasket (B).
2. Tighten the bolts (C) and the nuts (D) in a cross pattern in three steps; tighten the bolts and the nuts until they sit on the throttle body, tighten the bolts and the nuts until the gasket is compressed and both parts are contacted, tighten the bolts and the nuts to specified torque.
3. Connect the water bypass hoses (E).
4. Connect the throttle body connector (F).
5. Install the intake air duct (G).
- When torquing the screw of the hose band (H), do not overtighten the screw to a torque of 3.0 Nm or more.
- After tightening the screw of the hose band, make sure the clearance (I) is less than 0.04 in (1.0 mm).
6. Install the harness clip (J).
7. Connect the MAP sensor connector (K).
- Engine Coolant - Refill
- PCM - Reset
- PCM - Idle Learn
- Engine Cover - Install