LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2017 >> MDX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System / Engine Mechanical - Service Information (Except Hybrid) >> Removal and Installation >> Intake Manifold Removal and Installation >> Removal

Intake Manifold Removal and Installation: Removal

NOTE: Refer to the Exploded View if needed during this procedure.
  1. Injector Control Module - Remove 
  2. Air Cleaner - Remove 
  3. Intake Air Duct - Remove
    GHH320408Courtesy of HONDA, U.S.A., INC.
    1. Disconnect the breather pipe (A).

    2. Remove the intake air duct.

  4. EVAP Canister Purge Valve Connector and EVAP Canister Purge Hose - Disconnect 
  5. Throttle Body - Move 
    NOTE: Do not disconnect the water bypass hoses.
  6. PCV Hose and Brake Booster Vacuum Hose - Disconnect
    GHH320409Courtesy of HONDA, U.S.A., INC.
    1. Disconnect the brake booster vacuum hose (A) and the PCV hose (B).
  7. Upper Cover - Remove
    Fig 1: Upper Cover Loosening Sequence
    GHH320410Courtesy of HONDA, U.S.A., INC.
    1. Remove the upper cover mounting bolts and nuts sequentially in three steps.

    2. Remove the upper cover.

  8. Intake Manifold - Remove
    GHH320411Courtesy of HONDA, U.S.A., INC.
    1. Remove the intake manifold mounting bolts and nuts sequentially in three steps.

    2. Remove the intake manifold.

  9. Intake Manifold Base - Remove
    GHH320412Courtesy of HONDA, U.S.A., INC.
    1. Remove the intake manifold base mounting bolts and nuts sequentially in three steps.

    2. Remove the intake manifold base.