LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2017 >> MDX Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System / Engine Mechanical - Service Information (Except Hybrid) >> Removal and Installation >> Engine Oil Pan Removal and Installation >> Installation

Engine Oil Pan Removal and Installation: Installation

  1. Oil Pan Assembly - Install
    GHH320279Courtesy of HONDA, U.S.A., INC.
    1. Remove all of the old liquid gasket from the oil pan mating surfaces, the bolts, and the bolt holes.

    2. Clean and dry the oil pan mating surfaces.

    3. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the oil pan mating surface of the engine block and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.

    • If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
    • Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
    • If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
    GHH320280Courtesy of HONDA, U.S.A., INC.
    4. Install the dowel pins (A).

    5. Install the oil pan.

    Fig 1: Oil Pan Bolts Tightening Seqeuence With Torque Specifications
    GHH320281Courtesy of HONDA, U.S.A., INC.
    6. Tighten the bolts in three steps; tighten the bolts until the bolts sit on the oil pan, tighten the bolts until the gasket is compressed, tighten the bolts to specified torque.
    • Wait at least 30 minutes before filling the engine with oil.
    • Do not run the engine for at least 3 hours after installing the oil pan.
    Fig 2: Transmission assembly Mounting Bolts And Torque Converter Cover Bolts With Torque Specifications
    GHH320282Courtesy of HONDA, U.S.A., INC.
    7. Tighten the transmission assembly mounting bolts (A).

    8. Install the torque converter cover (B).

  2. CKP Sensor Connector - Connect 
  3. Rear Warm Up TWC Bracket - Install
    Fig 3: Rear Warm Up TWC Bracket Bolts With Torque Specifications
    GHH320283Courtesy of HONDA, U.S.A., INC.
    1. Loosely install the rear warm up TWC bracket (A), then tighten the rear warm up TWC bracket mounting bolts until the bracket and the bolts are contacted.

    2. Tighten the mounting bolts in the numbered sequence shown.

  4. Under-Floor TWC - Install - Refer to: Warm Up TWC Removal and Installation,  or Under-Floor TWC Removal and Installation 
  5. Secondary HO2S Connector - Connect 
  6. Engine Oil - Refill