LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2013 >> TL Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless/Power Door Locks/Security System >> Symptom Troubleshooting >> Security alarm system will not arm

Security alarm system will not arm

NOTE: Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, refer to the B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ), and troubleshoot the indicated DTCs first.
  1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  2. Select SECURITY from the BODY ELECTRICAL menu, and enter the DATA LIST with the HDS.
  3. Check the ON/OFF information in the DATA LIST when each switch is operating.
    • TRUNK LID/TAILGATE SWITCH
    • SECURITY HOOD SWITCH
    • DRIVER'S DOOR LOCK KNOB SWITCH (LOCK)
    • DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK)
    • FRONT PASSENGER'S DOOR LOCK KNOB SW (UNLOCK)
    • DRIVER'S DOOR SWITCH
    • FRONT PASSENGER'S DOOR SWITCH
    • DRIVER'S DOOR KEY CYLINDER SWITCH (LOCK)
    • DRIVER'S DOOR KEY CYLINDER SWITCH (UNLOCK)
    • DRIVER'S REAR DOOR KNOB SWITCH (UNLOCK)
    • PASSENGER'S REAR DOOR KNOB SW. (UNLOCK)
    • DRIVER'S REAR DOOR SWITCH
    • PASSENGER'S REAR DOOR SWITCH

    Is each switch information OK? 

    YES  - Intermittent failure, the system is OK at this time.

    NO  - Troubleshoot the indicated circuit.