LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2013 >> TL Base >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System >> Symptom Troubleshooting >> Interface dial buttons do not work

Interface dial buttons do not work

NOTE:
  • Check the vehicle battery condition first (see BATTERY TEST ).
  • Check the connectors for poor connections or loose terminals.
  • Check any official Honda service website for more service information about the navigation system.
  • Before troubleshooting, make sure you have anti-theft code.
  • After troubleshooting, enter the anti-theft code.
  1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
  2. Go into the System Diagnostic Mode , and use the Hard Key test under the Unit Check .

    Do the interface dial buttons work properly? 

    YES  - The system is OK at this time. ■

    NO  - Go to step 3.

  3. Measure the voltage between interface dial 5P connector terminal No. 4 and body ground.
    Fig 1: Measuring Voltage Between Interface Dial 5P Connector Terminal No. 4 And Body Ground
    G08071830Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there battery voltage? 

    YES  - Go to step 4.

    NO  - Repair an open in the wire between the driver's under-dash fuse/relay box and the interface dial. ■

  4. Measure the voltage between interface dial 5P connector terminal No. 3 and body ground.
    Fig 2: Measuring Voltage Between Interface Dial 5P Connector Terminal No. 3 And Body Ground
    G08071831Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there less than 0.2 V? 

    YES  - Go to step 5.

    NO  - Repair an open or high resistance in the wire between the interface dial and body ground (G501) (see CONNECTOR TO FUSE/RELAY BOX INDEX ). ■

  5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
  6. Disconnect audio-navigation unit connector H (28P).
  7. Disconnect the interface dial 5P connector.
  8. Check for continuity between audio-navigation unit connector H (28P) terminal No. 26 and interface dial 5P connector terminal No. 1.
    Fig 3: Checking Continuity Between Audio-Navigation Unit Connector H (28P) Terminal No. 26 And Interface Dial 5P Connector Terminal No. 1
    G08071832Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  - Go to step 9.

    NO  - There is an open in the wire between the interface dial and the audio-navigation unit. Replace the affected shielded harness. ■

  9. Check for continuity between audio-navigation unit connector H (28P) terminals No. 13 and No. 26.
    Fig 4: Checking Continuity Between Audio-Navigation Unit Connector H (28P) Terminals No. 13 And No. 26
    G08071833Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  - There is a short in the wires between the audio-navigation unit and the interface dial. Replace the affected shielded harness. ■

    NO  - Substitute a known-good interface dial , then reconnect all of the connectors, and recheck. If the symptom/indication goes away, replace the original interface dial . If the symptom/indication is still present, replace the audio-navigation unit . ■