LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> RDX >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starter Removal and Installation >> Installation

Starter Removal and Installation: Installation

  1. Install the starter, then install the starter cable (A) and connector (B). Make sure the starter cable crimped side of the ring terminal faces away from the starter when you connect it.
    Fig 1: Starter Cable, Connector And Harness Clamps With Torque Specifications
    G05444248Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the harness clamps (C).
  3. Install the intake manifold bracket (A), then install the harness clamp (B) and connector (C).
    Fig 2: Intake Manifold Bracket, Harness Clamp And Connector With Torque Specifications
    G05444249Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the A/C condenser fan shroud assembly (A), then connect the A/C condenser fan motor connector (B).
    Fig 3: A/C Condenser Fan Shroud Assembly And A/C Condenser Fan Motor Connector With Torque Specifications
    G05444250Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the support rod clamp bracket (A), then install the clips (B).
    Fig 4: Installing Support Rod Clamp Bracket With Torque Specifications
    G05444251Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the coolant reservoir.
    Fig 5: Installing Coolant Reservoir
    G05444252Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Connect the negative cable to the battery.
  8. Start the engine to make sure the starter works properly.
  9. Enter the anti-theft code for the audio system and the navigation system (if equipped).
  10. Set the clock (on vehicles without navigation).