Ignition Switch: Test
Replacement SRS components are located in the area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or serving.
- Make sure you have the anti-theft code for the audio or the navigation system, then write down the audio presets. Make sure the ignition switch is OFF.
- Disconnect the negative battery cable.
- Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ), and the steering column covers (see COLUMN COVER REMOVAL AND INSTALLATION ).
- Disconnect the 7P connector (A) from the ignition switch (B).
- Check for continuity between the terminals in each switch position according to the table.
- If the continuity checks do not agree with the table, replace the ignition switch (see REPLACEMENT ).
- After reconnecting the battery, enter the anti-theft code for the audio or the navigation system, then enter the client's audio presets, and set the clock.