LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> CSX Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Navigation System) >> Symptom Troubleshooting >> Navigation stays on with ignition switch off

Navigation stays on with ignition switch off

WARNING: This page is about a different car, the 2008 Acura CSX, 2007 Acura CSX, and 2006 Acura CSX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Always check the connectors for poor connections or loose terminals.
  • Before troubleshooting, get the navigation system anti-theft code, then write down the audio presets.
  • After troubleshooting, re-enter the anti-theft code, and re-initialize the navigation system, then enter the audio presets.
  • Check for aftermarket accessories that use the same power circuit. A feedback can cause this problem.
  1. Remove the key from the ignition.

    Does the navigation screen stay on? 

    YES  -Go to step 2.

    NO  -The system is OK at this time.

  2. The vehicle may have been used as a demonstration vehicle at an event like an auto show. In these events, power is often jumpered to the navigation system so that the ignition key is not needed in the vehicle. At the end of the show, the jumper wire may not have been removed. Check the navigation unit connector A (17P) for a "non-factory" jumper wire in series with the factory cable.

    Is there a jumper wire? 

    YES  -Remove the jumper wire, and re-test. Return the jumper wire to Tech Line.

    NO  -Go to step 3.

  3. Check if the audio unit works.

    Does the audio unit work with the ignition switch off? 

    YES  -Troubleshoot the ACC circuit for a short to power with another circuit.

    NO  -Replace the navigation unit (see NAVIGATION UNIT REMOVAL/INSTALLATION  ).