LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1993 >> Integra GS-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Clutches) >> Removal & Installation >> Clutch Assembly >> Removal

Clutch Assembly: Removal

WARNING: This page is about a different car, the 1994 Acura Integra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove battery and battery tray. Remove air cleaner housing and air inlet duct as an assembly. Disconnect ground cable from transaxle. Remove lower radiator hose clamp from transaxle hanger.
  2. Unplug connector from back-up light switch. Remove vehicle speed sensor connector. Disconnect cables and wiring harness clamp from starter. Remove clutch slave hydraulic hose bracket and slave cylinder.
  3. Remove 3 upper transaxle mounting bolts and lower starter motor bolts. Remove engine splash shield. Unplug oxygen sensor connector. Remove exhaust pipe from manifold and catalytic converter. Separate lower right ball joint from control arm. Remove right damper fork. Remove drive shafts and intermediate shafts. See FWD AXLE SHAFTS article in the DRIVE AXLES Section.
  4. Disconnect shift and change rods from transaxle. Remove front and rear engine braces. Remove clutch housing cover. Remove right front transaxle mount/bracket. Place jack under transaxle. Support engine with jack stands. Remove transaxle mount.
  5. Remove rear transaxle mount bracket and mount bolts from side of transaxle. Move transaxle away from engine until shaft clears clutch. Lower transaxle to remove from vehicle.
  6. Before removing clutch from flywheel, measure diaphragm spring fingers wear with feeler gauge, Handle (07936-3710100 ), Clutch Alignment Shaft (07NAF-PR30100 ), and Clutch Alignment Disc (07JAF-PM7011A ). Wear limit is 0.03" (.8 mm). Install flywheel holder. Unscrew pressure plate bolts 2 turns at a time in a crisscross pattern, to prevent warpage.