LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1989 >> Integra LS, 4D Hatchback, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Testing >> Set/Resume Switch

Set/Resume Switch

  1. Remove steering wheel. Check continuity between terminals "A" and "C" with "SET" switch on and terminals "B" and "C" with "RESUME" switch on. Continuity should be present. If continuity was not present, replace switch.
  2. To check slip ring, remove steering column lower cover. Disconnect 3-pin slip ring connector. Check continuity between Blue/Red wire and terminal "F", Lt. Green/Red wire and terminal "D", Lt. Green/Black wire and terminal "E" as you turn slip ring. See Fig 1 . Repair or replace slip ring if test results are not as specified.
    Fig 1: Testing Set/Resume Switch
    G90H08702Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove steering column lower cover. Disconnect 3-pin slip ring connector. Continuity should be present between terminals No. 1 and "A", terminals No. 2 and "C", and terminals No. 3 and "B", as you turn the slip ring. See Fig 2 .
Fig 2: Testing Slip Ring
G90J08703Courtesy of AMERICAN HONDA MOTOR CO., INC.