Purge Cut-Off Solenoid
- Locate purge cut-off solenoid. See appropriate VACUUM DIAGRAMS article. Ensure vehicle coolant temperature is less than activation specification. See PURGE OPERATING TEMPERATURE table for activation temperature.
- Turn ignition off. Disconnect vacuum hoses from solenoid valve. Using a hand-held vacuum pump, apply vacuum. Vacuum should hold. Start engine and allow vehicle to reach operating temperature. Apply vacuum. Vacuum should not hold. If vacuum holds, check voltage across solenoid terminals. If battery voltage is present, replace solenoid.
- If battery voltage is not present, check harness between solenoid and ECU for open or short to ground. If harness is okay, substitute a known good ECU. If condition is rectified, replace original ECU.