LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1988 >> Integra LS, 2D Hatchback, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Testing >> Set/Resume/Cancel Switch >> Legend

Set/Resume/Cancel Switch: Legend

  1. Remove dashboard lower panel. Disconnect 3-pin connector from wire harness. There should be continuity between terminals A and B with set switch on. There should be continuity between terminals A and C with resume switch on. There should be continuity between terminals A and B, and terminals A and C with cancel switch on. See Figure . If test results are okay, system is functioning properly. If test results are incorrect, go to next step.
    WARNING: If vehicle is equipped with Supplemental Restraint System (SRS), refer to STEERING section for removal of steering wheel. Failure to follow proper removal procedure may result in accidental deployment of air bag, possibly causing personal injury.
  2. Remove steering wheel. Disconnect 3-pin connector. See Figure . Check for continuity between terminals A and B with set switch on. There should be continuity. There should be continuity between terminals A and C with resume switch on. There should be continuity between terminals A and B, and terminals A and C with cancel switch on.
  3. Remove steering column lower cover. Disconnect 3-pin slip ring connector from wire harness. See Figure . There should be continuity between terminals No. 1 and A, terminals No. 3 and B, and terminals No. 2 and C, as you turn the slip ring.